Operation and maintenance of laser tattoo washing machine

1. Power on:
Connect the power cord and turn on the power.
2. Power on:
Confirm that the button of the emergency stop switch is in the raised position.
Insert the key into the lock switch and turn it to the on state. At this time, the internal consumption water pump runs and the system enters standby mode.
3. Laser output:
Gently press the first button to turn on the system and put it in a ready state.
Press the fourth frequency key to select setting 1 2 3 4 5 6 7 8 9 10 Hz to the appropriate level.
Press the second and third keys to adjust the energy to the appropriate level.
After aligning the gun head with the area to be treated, press the foot pedal to output the laser, and release the foot pedal to stop the laser output.
【 Note 】 When the system is in working mode, avoid aiming the gun head at dangerous parts (such as human eyes) to avoid accidentally stepping on the foot pedal and causing accidents due to laser output. Always leave the foot pedal before each treatment.
4. Shutdown
Press the first key on the screen to switch from ready to standby, put the system in standby mode, and shut down after 30 seconds.
Turn the lock switch to the off position to turn off the machine.
Unplug the power cord to turn off the power and turn off the power indicator light.
【 Note 】 It is strictly prohibited to replace the bald head while the system is in operation. 1. Clean the output lens:
The rear of the collimator is equipped with an output lens. It is recommended to check the surface of the lens for any splashes after each treatment. If present, please remove the output lens and gently wipe it with a cotton swab dipped in anhydrous ethanol.
2. It is recommended to replace the machine with water after 1-2 months of use, as this can increase the service life of the machine.
warning
It is strictly prohibited to check and clean the output lens when it is turned on
1. Supplement cooling water:
After 2-3 months of use, pay attention to observing the cooling water level from the water level observation hole. If the cooling water level is below the water line (during shutdown), please use a syringe to fill the water tank from the hole with a hole plug to the water line position.
Attention: The cooling water must be distilled water! It is recommended to use distilled water from hospital preparations or other brands of purified water, and it is important not to use tap water or other substandard imported water.
2. Special instructions
This machine is equipped with anti-interference measures in the software program. When starting up, the computer may automatically reset and the system restarts when transitioning from a paused state to a ready state or when there is excessive external interference.
When there is an unexpected power outage, the software program of this machine has a protection function, and it usually restarts after one minute.